October 2026 Newsletter: The Attenuation of the Terrifying

It’s the month of Halloween, and while we have discussed spooky sounds in the past, perhaps nothing is more frightening than the thought of end-users complaining about horrifyingly loud mechanical noise. Read on to learn more about attenuating the risk of receiving a terrifying noise complaint.

Objectionable sound from mechanical systems is typically related to a combination of the paths discussed below.  In other words, solving a noise issue in one of these mechanical paths may not result in adequately lowering the resultant sound level in occupied spaces to meet a standard or design goal.  Sound from all paths must be considered during mechanical noise control evaluations and attenuation may be needed for several of these paths, if not all of them.

Return and supply air duct paths are associated with duct-borne and duct break-out sound components.  Duct-borne sound typically enters an occupied space at the path’s termination at supply diffusers and return grilles.  However, before sound reaches these termination elements, sound can “break through” the walls of the duct and enter occupied spaces as well; this is of particular concern near main ducts or when ductwork is exposed to the room.  In both cases, the dominant source of sound is the fan within the air handling unit, although other sources can contribute too, such as local VAV or fan coil units.  Common attenuation options include duct silencers, internal lining, and duct lagging.

Another path that must be considered, especially when a noise-sensitive space is adjacent to rooftop equipment or a mechanical room, is radiated sound, which is airborne sound that propagates from the unit itself.  Sources could include every major piece of equipment on a project including air handling units, condenser and exhaust fans, compressors, cooling towers, and generators.  Attenuation options are typically incorporated through architectural elements including partition upgrades such as double-stud or masonry walls, floating floors, isolated ceilings, and additional mass layers in roof buildups.  Equipment manufacturers may have attenuation options to help reduce levels at the source, but these options and the level of attenuation they deliver may be limited.

Sound can also travel structurally from mechanical sources to occupied spaces, and structure-borne sound can often reach far and wide throughout a building; in some cases, it can be felt as well as heard.  Further, it is notoriously difficult to quantitatively predict sound levels from structure-borne sound.  Therefore, other techniques must be used to evaluate adequate attenuation options, which could include neoprene or spring mounts and hangers with minimum deflection properties.

The mechanical noise paths that should be considered for a particular project are not limited to the paths discussed above.  The important takeaway is that all relevant paths are additive and contribute to the overall sound level in a space, and therefore all paths must be considered and effectively controlled when hoping to meet a sound level design goal or standard.

Controlling mechanical noise can be a scary undertaking for a design team, that is unless a seasoned acoustical consultant is on board!  In other news, October is National Protect Your Hearing Month, remember to use a good set of ear plugs or muffs approaching one of these terrifyingly loud pieces of mechanical equipment.

 

Felicia runs Atlantic City!